Use with pressed for straight-line segment previews. Rubber Band Mode-when enabled, it previews the next segment to be drawn before placement of the new leading node.From Layer>Geometry, choose Separate curves to separate each curve into separate layers or Merge curves to consolidate selected curves into one layer. For example, the character 'a' is made up of two curves that can be a single 'curve object'. Add new curve to selected curves object-when enabled, the mode creates additional curves on the same layer as the initial curve-this gives better management of a multitude of curve layers.Preserve selection when creating new curves-when enabled, it keeps the previously drawn curve(s) selected so that their nodes and geometry can be more easily snapped to as you draw.To draw a straight line of a specific rotation and/or length, with a single uncurved line selected using the Move Tool, go to the Transform panel and adjust the Rotation and/or Length values.Īnother three modes in the Mode section can be used in conjunction with any one of the four modes above: To close the curve, click on the starting node. To complete the curve without closing it, press the.Line Mode-click and drag on the page to create a simple single-segment straight line.Polygon Mode-click repeatedly on the page to lay down each node a line is created with sharp nodes made up of straight segments.Smart Mode-click repeatedly on the page to lay down each node a best fitting curve is created without need for control handle adjustment.Pen Mode-click-drag on the page to create repeated nodes repositioning the displayed off-curve control handles at each node defines the shape of the next segment as you lay down nodes.
0 Comments
Leave a Reply. |